21.12
ipod touch review
Download the following needed files in this process.
2.3.3 Gingerbread Firmware
With bootloaders: (USE THIS ONE)
Without bootloaders:
Odin 1.7 Downloader
PIT File: gt-p1000_mr_PIT.zip
DBDATA
Flashing the 2.3.3 Gingerbread Firmware on Samsung Galaxy Tab P1000 Steps and Procedures Using ODIN:
1. Extract all the downloaded files in one folder.
2. Double click ODIN.exe to run the program.
3. Check these: Re-Partition
4. In the PDA section place the extracted main firmware .tar file.
5. Place the extracted .pit file in the PIT section .
6. Click the Start button and it will flash the firmware.
Wait until the whole process successfully completes...
7. Place the Samsung Galaxy Tab P1000 into Download Mode again. Hold the Power and Volume down button at the same time, then connect it to PC.
2. DO NOT SELECT or CHECK the REPARTITION checkbox: Place extracted dbdata.tar file into the PDA section.
3. Hit START button to flash the dbdata.tar file.
4. When the Flashing completes Switch the Samsung Galaxy Tab P1000 into RECOVERY MODE status.
Use the Volume Up and Down buttons to navigate and Home Button to select while in Recovery Mode.
1. Hold Power and Volume Up together, this will switch the device into recovery mode.
2. Release Power after holding it for a second but continue to hold the Volume Up button until recovery menu appears.
Select wipe cache
Select wipe data/factory reset.
Select reboot
That's all! The Samsung Galaxy Tab now runs in Android 2.3.3 Gingerbread Update.
Posted in: Samsung,Samsung Galaxy Tab P1000
0 komentar:
Posting Komentar